Luminex 100 IS Version 2.3 - Manual (Page 112)

Luminex 100 IS User Manual Version 2.3
x
MAP Technology
5 - 70 PN 89-00002-00-072 Rev. C
11. Establish preliminary off-plate commands. The system performs
preliminary off-plate commands before the first well command.
To establish a preliminary off-plate command, right-click
anywhere over the plate layout and select Preliminary Off-Plate
Cmd(s) from the menu.The command list dialog box appears
similar to Figure 5-40.
Click the OK button next to the Command List after you select
the desired commands. The white corner marker in the top left
corner of the plate (above the letter A) turns green to indicate an
off-plate command is established. The selected commands run
before the plate begins.
Figure 5-39. Preliminary Off-Plate Command (Corner) Marker
To clear preliminary off-plate commands, right-click on the corner
marker or plate layout and select Clear Off-Plate Cmd(s). See
Figure 5-39.
Figure 5-40. Plate Layout Tab, Off-Plate Commands
12. Insert off-plate commands. You can insert off-plate commands
that run after a single well, after a range of wells, or after rows or
columns of wells. The prompt sentence displayed should be
appropriate for your selection. For example, if you select row B,
the prompt “Establish the off-plate commands to run after wells
B1 through B12” appears.