Luminex 100 IS Version 2.3 - Manual (Page 183)

PN 89-00002-00-072 Rev. C B - 1
Luminex 100 IS System Installation
Overview
This appendix provides hardware, firmware, and software
installation procedures as required for new or system updates. On
new systems, the factory preinstalls the latest versions of the
firmware and software; you perform only the hardware installation.
Upgrades become available for enhancements or to repair a corrupted
file. Upgrade instructions or Luminex Technical Support may direct
you to sections in this appendix to perform a software or firmware
procedure.
If this is a new Luminex 100 IS 2.3 system installation, then only
perform the procedure in the following "Luminex 100 IS System
Setup" section. Otherwise, perform any of the following procedures
as required:
‰ Luminex 100 IS System Hardware Setup—If you are install-
ing the Luminex 100 IS 2.3 system hardware continue with
Luminex 100 IS System Setup (page B-1).
‰ Luminex 100 IS Software Installation—If you need to upgrade
or reinstall your Luminex 100 IS 2.3 system software, refer to
Luminex 100 IS 2.3 Software Installation (page B-14).
‰ Luminex Firmware Installation—If you need to perform a
firmware upgrade in your Luminex 100 analyzer, Luminex XYP
instrument, or Luminex SD system, refer to Luminex 100 IS 2.3
Firmware Installation (page B-21).
Luminex 100 IS
System Setup
Before connecting the system components, ensure that the facility
complies with all system and safety requirements. Read the safety
information that begins in Warnings and Notes (page 2-2). Position
the instrument to minimize temperature fluctuations.
B