Luminex 100 IS Version 2.3 - Manual (Page 113)

x
MAP Technology Using Luminex 100 IS 2.3 Software
PN 89-00002-00-072 Rev. C 5 - 71
To establish insert off-plate commands, select the desired wells,
then right-click over the plate layout. Select Insert Off-Plate
Cmd(s) from the menu. Select the desired commands and click
OK. The background of the established wells turn green.
To clear insert off-plate commands, select the wells to clear,
right-click on the plate layout and select Clear Selection from
the menu.
13. After you define the information on the General, Bead Set, and
Plate Layout tabs, click OK. Click Cancel to abort.
Each well can have a series of off-plate commands that run before
the next well is read. You can insert preliminary off-plate commands
that run before the first well.
Managing Assay Lots
You can edit standard and control lot information. Once a lot is used,
changing or modifying it will prompt you for a new lot name. This
includes batches that have been set up, but not yet acquired.
You can modify known lot concentration values. If you change the
known concentration for a used lot, the system prompts you to enter
a new lot name. If you change the concentration values in an unused
lot, the system updates the lot with the new concentration values.
For assay reagents specified in templates, you can create new lots,
edit lot information, select pre-existing lots for reuse, import lots,
and export lots.
When editing lot numbers, follow these lot handling rules:
• If you have entered lot information for a template, but you
have not used the template to set up a batch, you can edit the
lot value.
• If you have entered lot information and have used the template
to set up a batch (even if it has not been acquired), you must
rename the lot.
Table 5-10. Plate Layout Tab - Selection Shortcuts
Click column heading to select entire column.
Click row heading to select entire row.
Click the top left corner of the plate to select entire plate.