Luminex 100 IS Version 2.3 User Manual
Page 184
Luminex 100 IS User Manual Version 2.3
x
MAP Technology
B - 2
PN 89-00002-00-072 Rev. C
The following sections describe how to connect the Luminex 100 IS
system components. An Installation Drawing (page B-27) provides
clearances and other related information. Figure B-1 shows the
components of the system and how they should be placed.
Perform the following procedures to set up the system. Each of these
steps can be found on the page number shown in parentheses:
1. Connect the Luminex 100 analyzer and Luminex XYP to the PC
2. Install the Luminex XYP Instrument Sample Probe (page B-6)
3. Power On System Components (page B-8)
4. Accept the Luminex 100 IS 2.3 Software License Agreement
5. Adjust the Sample Probe Vertical Height (page B-8)
6. Install the Luminex XYP Instrument Reservoir (page B-9)
7. Calibrate and Verify the System (page B-10)
8. Install the SD System (page B-10)
9. Install the Luminex XYP Instrument Heater Block (page B-13)
Figure B-1 Luminex 100 IS System Setup
1. Monitor
4. Barcode Scanner
2. PC
5. Luminex SD system
3. Luminex XYP Instrument
6. Luminex 100 Analyzer
1
2
6
5
4
3