Figure 3.19—channel output names 129, Ppc1:channel 1 output – Watlow PPC-2000 User Manual
Page 155
PPC-2000 User’s Guide
Chapter 3: Operating with AnaWin 3
Doc.# 30002-00 Rev 2.3
Watlow Anafaze
129
Figure 3.19 Channel Output Names
Table 2.15 on page 56 correlates module I/O numbers with
screw terminals on the EITB.
Input Value (PV)
This field displays the scaled and filtered value measured by
the sensor attached to the corresponding input. This field is
read-only.
Range: Depends on input type selected. See Table 3.15.
Input Status
This field displays information about the sensor.
•
No Problem — sensor is functioning as expected.
•
Open Sensor — T/C or RTD not properly connected.
•
CMO — Common Mode Overvoltage, there is too much
noise on the sensor to make an accurate reading.
•
Shorted RTD sensor.
•
Ambient temperature error — temperature is outside
controller's operating range.
If two or more problems occur simultaneously the Input Status
lists the errors.
Input Type
Choose the input type appropriate for the sensor connected to
the corresponding input. Table 3.14 lists the choices available.
Select No Input if no sensor is attached to the input.
PPC1:Channel 1 Output
controller number
channel number