Watlow PPC-2000 - Manual (Page 42)

Chapter 2: Hardware Installation PPC-2000 User’s Guide
18 Watlow Anafaze Doc.# 30002-00 Rev 2.3
Table 2.4 System Modules and Addressing
* Maximum number of this type of module in a system
PPC-2010 Jumper Settings
Jumper settings in the PPC-2010 select whether the
communication lines are terminated or not. Each
communication port is configured separately. For installation
information, refer to Connecting RS-485 Communications on
page 81.
Wear a grounding strap and place components on static-free
grounded surfaces only. Locate jumpers 1 and 2. Table 2.5
describes the PPC-2010 jumper configuration. Install the
jumper in the orientation shown in Figure 2.4 on page 19.
Table 2.5 PPC-2010 Processor Module Jumpers
Module Max.
#*
Rotary Switch
Address Range
2010 (PROCESSOR) 1 0 (not switch selectable)
2021, 2022
(ANALOG IN)
2023, 2024, 2025
(ANALOG IN
HIGH ISOLATION)
4 1-4
2030
(ENCODER IN
ANALOG OUT)
4 11-14
2040
(DIGITAL I/O)
6 21-26,
2050, 2051
(ANALOG OUT)
4 31-34
2061, 2062
(DIGITAL OUT)
6 41-46
2070, 2071
(DIGITAL IN, 120Vac)
2072, 2073
(DIGITAL IN, 24Vac/DC)
4 51-54
Port Jumper #
Terminated
Position
Unterminated
Position
1 JU1 A B
2 JU2 A B