Analog output connections, Analog output connections 60, Figure 2.45—ppc-2030 analog out terminal block 60 – Watlow PPC-2000 User Manual
Page 84
Chapter 2: Hardware Installation
PPC-2000 User’s Guide
60
Watlow Anafaze
Doc.# 30002-00 Rev 2.3
Table 2.19
HD-15 Power Connections
Analog Output Connections
The connector pinouts are shown in Table 2.20. Use 16-28 AWG
wire. When making connections, tighten to 0.5 to 0.6 Nm, or 4.5
to 5.4 inch-pound.
Figure 2.45 PPC-2030 Analog Out Terminal Block
Table 2.20
Analog Output Connections on
Encoder In Analog Out Module
1
The AnaWin3 name is shown for the Encoder In Analog Out module with address
11 on the first PPC-2000 in the system. Refer to Outputs on page 135 for a full
explanation of Analog output naming.
Voltage
Pin Number
+5Vdc
12, 15
COM
13, 14
Module I/O
Number
Encoder In Analog
Out Module
Connections
AnaWin3 Name
(Input Spread-
sheet)
1
+
-
Analog Out 1
J1-1+
J1-1-
PPC1:EIAO 11.3.1
Analog Out 2
J1-2+
J1-2-
PPC1:EIAO 11.3.2
Analog Out 3
J2-3+
J2-3-
PPC1:EIAO 11.3.3
Analog Out 4
J2-4+
J2-4-
PPC1:EIAO 11.3.4
J2
J1
4-
4+
3-
3+
2-
2+
1-
1+
Outputs 3 & 4
Outputs 1 & 2
DIN Rail Latch