Watlow PPC-2000 - Manual (Page 241)

PPC-2000 User’s Guide Chapter 5: LogicPro and Modbus Reference
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 213
Table 5.58 System Commands
Database
Offset
Modbus
Address
Name
Reset
After
Host
Write
Action
1 04051
Reload
Defaults
Reset
Load defaults to most run-time
parameters. The exceptions are
protocol, baud, parity, address,
system HW config, system com-
mands, system status, program
version, change data queue,
system error log, real time clock
and analog input calibration
data.
2 04052 Reserved N/A
3 04053 Reserved N/A
4 04054
RAM Clear
Reset
Reset
Clear RAM, reset controller and
load defaults
5 04055
Watchdog
Test
Reset Force watchdog timeout
6 04056 Start Logic Reset Start logic program
7 04057 Reserved N/A
8 04058 Stop Logic Reset Stop logic program
9 04059
Loop
Startup
Latched
0=Start control loops in off
mode. Undo not available.
1=Start control loops from last
mode stored in memory.
10 04060
AC
Frequency
Latched
0=60Hz
1=50Hz
11 04061
Logic Star-
tup
Latched
0=Start logic program when
commanded.
1=Start logic program on star-
tup.
12 04062 Reset PPC Reset Reset controller