Watlow PPC-2000 - Manual (Page 79)

PPC-2000 User’s Guide Chapter 2: Hardware Installation
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 55
Connecting Encoders and Analog Outputs to
the PPC-2030
The PPC-2030 accepts four encoder inputs and outputs four
current or voltage signals. Encoder signals are connected to the
module via two HD-15 cables. These cables may be used in
conjunction with up to two EITBs or may be connected directly
from the encoders to the module.
Connect analog outputs via the analog output terminal block as
shown in Figure 2.39.
Figure 2.39 PPC-2030 Connections (Bottom View)
Connecting the Encoder Input Cable to the PPC-2030
Connect the 15-pin, HD cable(s) between J1 or J2 on the PPC-
2030 shown in Figure 2.39 and the encoder input terminal
block (EITB).
Figure 2.40 on page 56 illustrates the EITB. Table 2.15 on page
56 shows the EITB pinout and Table 2.18 on page 59 shows the
HD D-type connector pinout. Analog Output Connections on
page 60 discusses analog outputs from the PPC-2030.
NOTE! If more than one EITB has been installed, it may be
useful to label both ends of the HD-15 connector and
each EITB with the corresponding module address
and jack number.
J4
J3
J2
J1
4-
4+
3-
3+
2-
2+
1-
1+
J4 Encoder
Input
connector
(HD-15 female)
J3 Encoder
Input
connectors
(HD-15 female)
J1 Analog
Output Terminal
J2 Analog
inputs 3 & 4
inputs 1 & 2
Output Terminal
Block
outputs 3 & 4
Block
outputs 1 & 2