Panel mounting, Panel mounting 33, Figure 2.18—tb50 panel mounted 33 – Watlow PPC-2000 User Manual
Page 57
Advertising
PPC-2000 User’s Guide
Chapter 2: Hardware Installation
Doc.# 30002-00 Rev 2.3
Watlow Anafaze
33
Panel Mounting
NOTE!
When panel mounting terminal boards, remove the
DIN rail brackets before mounting the boards.
Figure 2.18 TB50 Panel Mounted
Stand-offs are provided for all terminal boards.
1.
Remove the DIN rail mounting brackets from terminal
board.
2.
Select a location with enough clearance for the board and
its SCSI cable. Refer to Figure 2.15 on page 31 for installed
clearances.
3.
When a location has been determined for board, mark the
four mounting holes.
4.
Drill and tap the four #6-32 mounting holes.
5.
Place the terminal board so the standoffs are aligned with
the holes. insert the screws in to the standoffs and tighten
them.
Standoff
Advertising