HP Integrity NonStop H-Series - Manual (Page 36)

Installation and Configuration
WVP NonStop Storage Analyzer User Guide – 536988-001
- 36 -
2-3-4 Web ViewPoint configuration files
This section lists the configuration assigns that exist in the Web ViewPoint configuration files that
are either added during the install or are important for the product activation.
Table 6 ASSIGNS
Name Location Possible Values Description
LICENSE-FILE
WVPCONF
LICFILE
This is a shared Assign file. Storage Analyzer uses
the same license file as is used by Web ViewPoint
by appending its license to the existing license file.
Hence the value of this must be the license file
being used by Web ViewPoint.
WVP-LOCATION STRTWVP WVP $Vol.Sub
volume
This assign is added during the install of SA and
represents the location of the WVP configuration
files.
[Back to TOC]
2-3-5 Work Files
This section describes the data files that are created by the SA Host process at the scheduled time
of the daily run. These files are created in the Store Volume specified in Runtime Admin under sub
volume that follows the “SAyymmdd” notation, The prefix “yymmdd” being the two digit year, month
and day (of the collection) respectively.
Table 7 Work Files for Storage Analyzer
Name Enscribe
File Type
Description
F100 K Used to store all the 100% full file info.
F90 K Used to store all the Over 90% full file info.
FAGEOLD K Used to store all the files that meet the old age criteria as specified in the
Runtime Admin
FALRTDD
K Used to store any matching disk alerts defined in the Alert Admin . The Alert
definitions are read from ALDEFDD file
FALRTFD
K Used to store any matching file alerts defined in the Alert Admin . The Alert
definitions are read from ALDEFFD file.
FALRTFH *
K Used to store any matching hourly alerts.
The Alert definitions are read from ALDEFFH file
Note: The Hourly alerts are not currently being supported in Storage Analyze
It’s reserved for future release.