HP Integrity NonStop H-Series - Manual (Page 76)

WVP NonStop Storage Analyzer User Guide – 536988-001
- 76 -
TACL FUP DUP command is used to execute the DUPLICATE operation. E.g. the above is
equivalent to the following TACL command:
-- FUP DUP $IDEL3.DEV1.COMPILE, SAHOST.COMPILE1
 Move – Moves (copies to the destination and removes from the source) a file to a specified
location. The user can specify the destination as either $volume.sub volume.filename or sub
volume.filename (volume of the source file is used in this case) or just the filename (volume.sub
volume of the source file is used in this case). It also gives you an option to overwrite/purge, in
case the destination file already exists. Result of the operation is displayed in a separate popup.
Figure 4-60 Command – Move
TACL FUP DUP and FUP PURGE commands are used to execute the MOVE operation. E.g.
the above is equivalent to the following TACL commands:
-- FUP DUP $IDEL3.AAIQA2.WDSD001, $IDEL3.AAIQA2.WDSD002
-- FUP PURGE $IDEL3.AAIQA2.WDSD001
 Rename – renames a file to a specified filename. The user can specify the destination as either
sub volume.filename (volume of the source file is used in this case) or just the filename
(volume.sub volume of the source file is used in this case). It also gives you an option to
overwrite/purge, in case the destination file already exists. Result of the operation is displayed in
a separate popup.
Note: File rename operation only works when the file to be renamed is within the same volume,
otherwise an error 15 is thrown.