HP LaserJet 6pmp Printer series - Manual (Page 109)

Regulatory Information
FCC Regulations
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy. If it is not installed and used in
accordance with the instructions, it may cause harmful interference to
radio communications; however, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
•
Re-orient or relocate receiving antenna.
•
Increase separation between equipment and receiver.
•
Connect equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult your dealer or an experienced radio/TV technician.
N o t e Any changes or modifications not expressly approved by
Hewlett-Packard could void the user’s authority to operate this
equipment.
Use of a shielded printer cable is required to comply within the Class B
limits of Part 15 of the FCC rules.
A-2 Printer Specifications
EN