HP LaserJet 6pmp Printer series - Manual (Page 56)

Loading Media into Tray 1
Tray 1 (multi-purpose) holds up to
100 sheets of paper or up to 10 envelopes.
1 Grasp Tray 1 by the two finger tabs
and pull the top down.
2 Pull out the plastic tray extender by
grasping the center finger tab. If the
media being loaded is longer than
9 inches (229 mm), also pull out the
wire tray extender.
3 Slide the paper width guide to the far
right side of the tray.
4 Place media into the tray (short-edge
in, print-side up). The media should
be flush left, under the tab on the left
paper guide.
5 Slide the paper width guide to the left
until it lightly touches the media
without bending it. Make sure the
media fits under the tab on the paper
width guide.
N o t e
Do not add media to Tray 1 while the
printer is printing. This could cause a
paper jam.
Tray 1 hint
•
For letterhead orientation in Tray 1,
see page 3-11.
3
P
rint
ing
T
asks
EN
Printing Tasks 3-5