HP LaserJet 6pmp Printer series User Manual
Page 128
6
Remove the SIMM from the antistatic
package while avoiding touching the
metal contacts.
7
Hold the SIMM so the notch on one
end is on the bottom and the metal
contacts face toward the slot.
8
Hold the SIMM at a 30 degree angle
to the first available slot from the
right. Push the edge of the board
evenly and firmly into the slot (
D
).
Rotate the SIMM to the right (
E
) until
the board snaps into the locking tabs.
Repeat steps 6, 7, and 8 for each
SIMM being installed.
9
Replace the side panel by lining up
the alignment arrows (
F
) and sliding
the panel backwards (
G
) until the
release button latches into place (
H
).
Close the top cover.
10
Reinstall the interface cable(s) and
power cord. Turn the printer on.
Continue on the following page.
D
Memor
y
Insta
llat
ion
EN
Memory Installation
D-3