HP LaserJet 6pmp Printer series - Manual (Page 121)

Double Side Seam Envelopes
Double side seam construction has vertical seams at both ends of the
envelope rather than diagonal seams. This style generally performed
adequately in Hewlett-Packard testing, but may be more likely to
wrinkle.
Envelopes with Adhesive Strips or Flaps
Envelopes with a peel-off adhesive strip or with more than one flap that
folds over to seal must use adhesives compatible with the heat and
pressure of the fusing rollers in the printer. The extra flaps and strips
may result in wrinkling or creasing, and may cause jamming.
Envelope Storage
Proper storage of envelopes helps contribute to quality printing:
•
Envelopes should be stored in an air-tight container, protecting them
from moisture.
•
Envelopes should be kept flat when being stored. If air becomes sealed
in an evelope creating an air bubble the envelope may wrinkle during
printing.
Envelope Margins
The following table gives typical address margins for a Commercial #10
or DL envelope. For envelopes of other sizes, adjust the margin settings
as desired.
Type of Address Top Margin Left Margin
Return Address 0.6 in (15 mm) 0.6 in (15 mm)
Delivery Address 2 in (51 mm) 3.5 in (89 mm)
N o t e For the best print quality, position margins no closer than .5 inch
(13 mm) from the edges of the envelope.
Try to avoid printing over the area where the envelope’s three back flaps
meet.
B-8 Media Specifications
EN