Attaching a parallel printer cable – HP LaserJet 6pmp Printer series User Manual
Page 19
Attaching a Parallel Printer Cable
To ensure reliability use an IEEE-1284
compliant parallel cable (these cables are
clearly marked with “IEEE-1284”). Only
IEEE-1284 cables support all of the
printer’s advanced functions.
C a u t i o n
Make sure power is off.
1
Locate the interface cable door (
A
) at
the back of the printer. Pull the door
out using the finger tab for leverage.
2
If using a parallel cable with a large
B-type end, connect the cable into
port (
B
). Snap the wire clips in place
to secure the cable to the printer.
If using a parallel cable with a small
C-type end, connect the cable into
port (
C
).
The cables should install easily. If
installation is difficult, check the
cable orientation.
3
Replace the interface cable door
while allowing the cable to feed
through its appropriate hole.
4
Connect the other end of the cable to
the proper connector on the computer.
Go to
Step 7. Attach the Power Cord
,
on page 1-12.
1-10
Printer Setup
EN