Sony DCR-TRV70 - Manual (Page 190)

190
Symptom Cause and/or Corrective Actions
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at
least one hour to acclimatize (p. 202).
• Some troubles have occurred in your camcorder.
c Remove the cassette and insert it again, then operate
your camcorder.
c Disconnect the AC Adaptor from a wall outlet or
remove the battery pack, then reconnect it in about one
minute. Turn the power on. If the functions still do not
work, press the RESET button using a sharp-pointed
object. (If you press the RESET button, all the settings
(DCR-TRV70: except the network settings) including the
date and time return to the default) (p. 15, 16, 211).
• This is because some functions use a linear mechanism.
This is not a malfunction.
• Charging the battery pack is completed.
• The battery pack is not properly installed.
c Install it properly (p. 15).
• The POWER switch is not set to OFF (CHG).
c Set it to OFF (CHG) (p. 16).
c Charge the battery pack fully again (p. 16).
• The battery pack is not properly installed.
c Install it properly (p. 15).
• Something is wrong with the battery pack.
c If the symptom persists, disconnect the plug from the
wall outlet as soon as possible to cut off the power, and
contact your Sony dealer or local authorized Sony
service facility.
• DISPLAY/BATT INFO is pressed.
c Press the LCD screen lightly.
c Press DISPLAY/BATT INFO on your camcorder or
DISPLAY on the Remote Commander (p. 40).
c Adjust the screen (CALIBRATION) (p. 204).
• The USB cable was connected before installation of the
USB driver was complete.
c Uninstall the USB driver and reinstall the USB driver
(p. 148, 153).
• USB STREAM in is set to OFF in the menu settings.
c Set it to ON (p. 180).
• Your camcorder is on the point of falling into moisture
condensation (p. 202).
c Remove the battery pack, then install it again (p. 15).
The melody or beep sounds for
five seconds.
No function works though the power
is on.
When you set the POWER switch to
VCR or OFF (CHG), if you move
your camcorder, you may hear a
clattering sound from inside your
camcorder.
While charging the battery pack, the
CHARGE (charge) lamp is not lit.
You cannot charge the battery pack.
The power runs out quickly, even
though the remaining battery time
indicator is full.
While charging the battery pack, the
CHARGE (charge) lamp flashes.
The buttons do not appear on the
touch panel.
The buttons on the LCD screen do
not work.
Image data cannot be transferred to
your computer via the USB
connection.
The cassette cannot be ejected even if
the cassette lid is open.
The cassette cannot be ejected.
Types of trouble and how to correct trouble