Sony DCR-TRV70 - Manual (Page 81)

81
Editing
Dubbing only desired scenes – Digital program editing (on a tape)
Step 2: Setting the VCR for operation
When connecting with the A/V connecting cable, your camcorder sends the control
signal by infrared rays to the remote sensor on the VCR.
The POWER switch should be set to .
Operate by touching the panel.
(1) Turn the power of the connected VCR on.
If your VCR has an input selector, set it to the input mode. When you connect
a video camera recorder, set its power switch to VCR/VTR.
(2) Press FN to display PAGE1.
(3) Press MENU.
(4) Select VIDEO EDIT in , then press EXEC.
(5) Select TAPE, then press EXEC.
(6) Press EDIT SET.
(7) Select CONTROL, then press EXEC.
(8) When connecting with the A/V connecting cable, select IR, then press EXEC.
When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to
“Step 3: Adjusting the synchronization of the VCR” on page 84.
(9) Select IR SETUP, then press EXEC.
(10) Select the IR SETUP code of your VCR, then press EXEC. Check the code in
“About the IR SETUP code” (p. 83).
4 5
7 9
6
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
END
RET. EXEC
I R
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
RET. EXEC
3
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
RET. EXEC
I R
i. L I NK
END
0:32:30:14
TOTAL
SCENE 0:00:00:00
0
V I DEO ED I T
MARK
I N START ED I T
SET UNDO
END
OTHERS
DATA CODE
BEEP
COMMANDER
D I SPL AY
V I DEO ED I T
EXIT
RET. EXEC
RETURN
TAPE
MEMORY
END
(continued on the following page)