Sony DCR-TRV70 - Manual (Page 96)

96
Audio dubbing
To add new sound more precisely
Press ZERO SET MEMORY at the point where you want to stop recording later during
playback.
Follow Step 2 in “Using the touch panel” on page 95. Recording automatically stops at
the point where ZERO SET MEMORY was pressed.
We recommend that you add new sound on the tape recorded with your
camcorder
If you add new sound on the tape recorded with another camcorder (including another
DCR-TRV60/TRV70), the sound quality may become worse.
Monitoring the new recorded sound
The POWER switch should be set to .
Operate by touching the panel.
(1) Play back the tape on which you added audio.
(2) Press FN to display PAGE1.
(3) Press MENU.
(4) Select AUDIO MIX in
, then press EXEC.
(5) Press r/R to adjust the balance between the original sound (ST1) and the new
sound (ST2), then press EXEC.
About five minutes after you disconnect the power source or remove the
battery pack, the setting of AUDIO MIX returns to the original sound (ST1)
only. The default setting is original sound only.
VCR SET
H i F i SOUND
AUD I O M I X
A/V
c DV OUT ST1 ST2
EXIT
RET. EXEC R r
AUDIO DUB
x
X
N