Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 170)

152 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
RIP parameter configuration
Syntax: filter filter-num permit | deny source-ip-address | any source-mask | any [log]
Applying a RIP route filter to an interface
Once you define RIP route filters, you must assign them to individual interfaces. The filters do not
take effect until you apply them to interfaces. When you apply a RIP route filter, you also specify
whether the filter applies to learned routes or advertised routes:
• Out filters apply to routes the Layer 3 Switch advertises to its neighbor on the interface.
• In filters apply to routes the Layer 3 Switch learns from its neighbor on the interface.
To apply RIP route filters to an interface, enter commands such as the following.
Brocade(config)#interface ethernet 1/1/2
Brocade(config-if-e10000-1/1/2)#ip rip filter-group in 2 3 4
These commands apply RIP route filters 2, 3, and 4 to all routes learned from the RIP neighbor on
port 1/1/2.
Syntax: [no] ip rip filter-group in | out filter-list