Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual

Page 236

Advertising
background image

218

Brocade ICX 6650 Layer 3 Routing Configuration Guide

53-1002603-01

Displaying OSPF information

The num parameter displays only the entry in the specified index position in the neighbor table. For
example, if you enter “1”, only the first entry in the table is displayed.

The detail parameter displays detailed information about the neighbor routers.

These displays show the following information.

TABLE 37

CLI display of OSPF neighbor information

Field

Description

Port

The port through which the Layer 3 Switch is connected to the neighbor.
The port on which an OSPF point-to-point link is configured.

Address

The IP address of this Layer 3 Switch interface with the neighbor.

Pri

The OSPF priority of the neighbor:

For multi-access networks, the priority is used during election of the Designated Router
(DR) and Backup designated Router (BDR).

For point-to-point links, this field shows one of the following values:

1 = point-to-point link

3 = point-to-point link with assigned subnet

State

The state of the conversation between the Layer 3 Switch and the neighbor. This field can have
one of the following values:

Down – The initial state of a neighbor conversation. This value indicates that there has
been no recent information received from the neighbor.

Attempt – This state is only valid for neighbors attached to non-broadcast networks. It
indicates that no recent information has been received from the neighbor.

Init – A Hello packet has recently been seen from the neighbor. However, bidirectional
communication has not yet been established with the neighbor. (The router itself did not
appear in the neighbor's Hello packet.) All neighbors in this state (or higher) are listed in
the Hello packets sent from the associated interface.

2-Way – Communication between the two routers is bidirectional. This is the most
advanced state before beginning adjacency establishment. The Designated Router and
Backup Designated Router are selected from the set of neighbors in the 2-Way state or
greater.

ExStart – The first step in creating an adjacency between the two neighboring routers. The
goal of this step is to decide which router is the master, and to decide upon the initial
Database Description (DD) sequence number. Neighbor conversations in this state or
greater are called adjacencies.

Exchange – The router is describing its entire link state database by sending Database
Description packets to the neighbor. Each Database Description packet has a DD
sequence number, and is explicitly acknowledged. Only one Database Description packet
can be outstanding at any time. In this state, Link State Request packets can also be sent
asking for the neighbor's more recent advertisements. All adjacencies in Exchange state
or greater are used by the flooding procedure. In fact, these adjacencies are fully capable
of transmitting and receiving all types of OSPF routing protocol packets.

Loading – Link State Request packets are sent to the neighbor asking for the more recent
advertisements that have been discovered (but not yet received) in the Exchange state.

Full – The neighboring routers are fully adjacent. These adjacencies will now appear in
router links and network link advertisements.

Neigh Address

The IP address of the neighbor:
For point-to-point links, the value is as follows:

If the Pri field is "1", this value is the IP address of the neighbor router interface.

If the Pri field is "3", this is the subnet IP address of the neighbor router interface.

Neigh ID

The neighbor router ID.

Ev

The number of times the neighbor state changed.

Advertising