Displaying statistics – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual

Page 472

Advertising

454

Brocade ICX 6650 Layer 3 Routing Configuration Guide

53-1002603-01

Displaying VRRP and VRRP-E information

Displaying statistics

To display statistics on most Brocade devices, enter the show ip vrrp stat command at any level of
the CLI.

To display IPv6 VRRP-E v3 statistics on a device, enter the following command at any level of the
CLI.

current dead interval

The current value of the dead interval. This value is equal to the value
configured for the dead interval.
If the value for the dead interval is not configured, then the current dead
interval is equal to three times the Hello interval plus Skew time (where Skew
time is equal to 256 minus priority divided by 256).
NOTE: This field does not apply to VRRP Owners.

preempt mode

Whether the backup preempt mode is enabled. If the backup preempt mode is
enabled, this field contains “true”. If the mode is disabled, this field contains
“false”.

advertise backup

Whether Backup routers send Hello messages to the Master.

TABLE 83

Output from the show ip vrrp vrid command (Continued)

Field

Description

Brocade#show ip vrrp stat

Interface ethernet 1/1/5

rxed vrrp header error count = 0

rxed vrrp auth error count = 0

rxed vrrp auth passwd mismatch error count = 0

rxed vrrp vrid not found error count = 0

VRID 1

rxed arp packet drop count = 0

rxed ip packet drop count = 0

rxed vrrp port mismatch count = 0

rxed vrrp ip address mismatch count = 0

rxed vrrp hello interval mismatch count = 0

rxed vrrp priority zero from master count = 0

rxed vrrp higher priority count = 0

transitioned to master state count = 1

transitioned to backup state count = 1

Brocade#show ipv6 vrrp-extended stat ve 51

Interface ethernet v51