Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 450)

432 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Additional VRRP and VRRP-E parameter configuration
When the no ipv6 router vrrp-extended command is enabled, all IPv6 VRRP-E instances for a
specific VRID are deleted from the interface, and the running configuration is lost when writing to
flash. You must enable the write memory command to save your configuration. The following
message is displayed when the no ipv6 router vrrp-extended command is enabled.
Brocade Router2(config)#no ipv6 router vrrp-extended
ipv6 router VRRP-E is disabled. All VRRP-E (ipv6) config data will be lost when
writing to flash!!
Additional VRRP and VRRP-E parameter configuration
You can modify the following VRRP and VRRP-E parameters on an individual VRID basis. These
parameters apply to both protocols:
• Authentication type (if the interfaces on which you configure the VRID use authentication)
• Router type (Owner or Backup)
NOTE
For VRRP, change the router type only if you have moved the real IP address from one router to
another or you accidentally configured the IP address Owner as a Backup.
For VRRP-E, the router type is always Backup. You cannot change the type to Owner.
• Suppression of RIP advertisements on Backup routes for the backed-up interface
• Hello interval
• Dead interval
• Backup Hello messages and message timer (Backup advertisement)
• Track port
• Track priority
• Backup preempt mode
• Timer scale
• VRRP-E slow start timer
Refer to “VRRP and VRRP-E parameters” on page 422 for a summary of the parameters and their
defaults.