Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 272)

254 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying OSPF V3 Information
Changing the key rollover timer
Configuration changes for authentication takes effect in a controlled manner through the key
rollover procedure as specified in RFC 4552, Section 10.1. The key rollover timer controls the
timing of the configuration changeover. The key rollover timer can be configured in the IPv6 router
OSPF context, as the following example illustrates.
Brocade(config-ospf6-router)#key-rollover-interval 200
Syntax: key-rollover-interval time
The range for the key-rollover-interval is 0–14400 seconds. The default is 300 seconds.
Clearing IPsec statistics
This section describes the clear ipsec statistics command for clearing statistics related to IPsec.
The command resets to 0 the counters (which you can view as a part of IPSecurity Packet
Statistics). The counters hold IPsec packet statistics and IPsec error statistics. The following
example illustrates the show ipsec statistics output.
To clear the statistics, enter the clear ipsec statistics command as in the following example.
Brocade#clear ipsec statistics
Syntax: clear ipsec statistics
This command takes no parameters.
Displaying OSPF V3 Information
You can display the information for the following OSPF V3 parameters:
• Areas
• Link state databases
• Interfaces
• Memory usage
• Neighbors
• Redistributed routes
• Routes
• SPF
Brocade#show ipsec statistics
IPSecurity Statistics
secEspCurrentInboundSAs 1 ipsecEspTotalInboundSAs: 2
secEspCurrentOutboundSA 1 ipsecEspTotalOutboundSAs: 2
IPSecurity Packet Statistics
secEspTotalInPkts: 20 ipsecEspTotalInPktsDrop: 0
secEspTotalOutPkts: 84
IPSecurity Error Statistics
secAuthenticationErrors 0
secReplayErrors: 0 ipsecPolicyErrors: 13
secOtherReceiveErrors: 0 ipsecSendErrors: 0
secUnknownSpiErrors: 0