Displaying ospf graceful restart information, Displaying ospf, Graceful restart information – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual

Page 244

Advertising
background image

226

Brocade ICX 6650 Layer 3 Routing Configuration Guide

53-1002603-01

Displaying OSPF information

Displaying OSPF graceful restart information

To display OSPF graceful restart information for OSPF neighbors, use the show ip ospf neighbors
command.

Brocade#show ip ospf neighbors

Port Address Pri State Neigh Address Neigh ID Ev Opt Cnt

1/1/2 192.168.50.10 0 FULL/OTHER 192.168.50.1 10.10.10.30 21 66 0

< in graceful restart state, helping 1, timer 60 sec >

Syntax: show ip ospf neighbor

Use the following command to display Type 9 grace LSAs on a Brocade Layer 3 switch.

Brocade#show ip ospf database grace-link-state

Graceful Link States

Area Interface Adv Rtr Age Seq(Hex) Prd Rsn Nbr Intf IP

0 eth 1/1/2 10.2.2.2 7 80000001 60 SW 10.1.1.2

Syntax: show ip ospf database grace-link-state

Table 41

defines the fields in the show output.

TABLE 41

CLI display of OSPF database grace LSA information

Field

Definition

Area

The OSPF area that the interface configured for OSPF graceful restart is
in.

Interface

The interface that is configured for OSPF graceful restart.

Adv Rtr

The ID of the advertised route.

Age

The age of the LSA in seconds.

Seq (Hex)

The sequence number of the LSA. The OSPF neighbor that sent the LSA
stamps the LSA with a sequence number. This number enables the
FastIron and other OSPF routers to determine the most recent LSA for a
given route.

Prd

The grace period. The number of seconds that the neighbor routers
should continue to advertise the router as fully adjacent, regardless of
the state of database synchronization between the router and its
neighbors. Since this time period begins when the grace LSA LS age is
equal to 0, the grace period terminates when either the LS age of the
grace LSA exceeds the value of a grace period or the grace LSA is flushed.

Rsn

The reason for the graceful restart. Possible values:

UK – Unknown

RS – Software restart

UP – Software upgrade or reload

SW – Switch to redundant control processor

Nbr Intf IP

The IP address of the OSPF graceful restart neighbor.

Advertising