Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 273)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 255
53-1002603-01
Displaying OSPF V3 Information
• Virtual links
• Virtual neighbors
• IPsec
Displaying OSPF V3 area information
To display global OSPF V3 area information for the Brocade device, enter the following command at
any CLI level.
Syntax: show ipv6 ospf area [area id]
You can specify the area-id parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1.
• As a numerical value from 0–2,147,483,647.
The area-id parameter restricts the display to the specified OSPF area.
This display shows the following information.
TABLE 43 OSPF V3 area information fields
Field Description
Area The area number.
Interface attached to this area The router interfaces attached to the area.
Number of Area scoped LSAs Number of LSAs with a scope of the specified area.
SPF algorithm executed The number of times the OSPF Shortest Path First (SPF) algorithm is executed
within the area.
SPF last updated The interval in seconds that the SPF algorithm was last executed within the
area.
Current SPF node count The current number of SPF nodes in the area.
Router Number of router LSAs in the area.
Network Number of network LSAs in the area.
Indx The row number of the entry in the router OSPF area table.
Area The area number.
Maximum hop count to nodes. The maximum number of hop counts to an SPF node within the area.
Brocade#show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 1/1/3 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
...