Displaying short-path forwarding combinations – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual

Page 462

Advertising

444

Brocade ICX 6650 Layer 3 Routing Configuration Guide

53-1002603-01

Additional VRRP and VRRP-E parameter configuration

The revert-priority value parameter uses the priority value as the threshold to determine whether
the short-path forwarding (SPF) behavior is effective. Typically, when short-path forwarding is
enabled, the Backup router enforces SPF. For each port that goes down, the current priority of the
VRRP-E router is lowered by the number specified in the track-port command. When the current
priority is lower than the threshold, the SPF behavior is temporarily suspended and reverts back to
the pre-SPF VRRP-E forwarding behavior. The value range is from 1 through 255.

Displaying short-path forwarding combinations

When short-path forwarding ( SPF) is configured, the output of the following show commands
include the SPF information:

•

show run

•

show ip vrrp-e brief

•

show ip vrrp-e vrid vrid

The following example displays information about VRID 1 when only short-path forwarding is
configured.

Brocade# show ip vrrp-e vrid 1

VRID 1

Interface ethernet v100

state backup

administrative-status enabled

priority 110

current priority 90

hello-interval 1000 msec

dead-interval 0 msec

current dead-interval 3500 msec

preempt-mode true

virtual ip address 10.1.1.3

virtual mac address 02e0.5289.7001

advertise backup: disabled

master router 10.1.1.1 expires in 00:00:02.6

track-port 1/1/13(down)

short-path-forwarding enabled

The following example displays information about VRID 1 when short-path forwarding and
revert-priority are configured.