Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 172)

154 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying CPU utilization statistics
Displaying CPU utilization statistics
You can display CPU utilization statistics for RIP and other IP protocols. To display CPU utilization
statistics for RIP for the previous five-second, one-minute, five-minute, fifteen-minute, and runtime
intervals, enter the show process cpu command at any level of the CLI.
If the software has been running less than 15 minutes (the maximum interval for utilization
statistics), the command indicates how long the software has been running, as shown in the
following example.
To display utilization statistics for a specific number of seconds, enter a command such as the
following.
Brocade#show process cpu
Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
ARP 0.01 0.03 0.09 0.22 9
BGP 0.04 0.06 0.08 0.14 13
GVRP 0.00 0.00 0.00 0.00 0
ICMP 0.00 0.00 0.00 0.00 0
IP 0.00 0.00 0.00 0.00 0
OSPF 0.00 0.00 0.00 0.00 0
RIP 0.04 0.07 0.08 0.09 7
STP 0.00 0.00 0.00 0.00 0
VRRP 0.00 0.00 0.00 0.00 0
Brocade#show process cpu
The system has only been up for 6 seconds.
Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
ARP 0.01 0.00 0.00 0.00 0
BGP 0.00 0.00 0.00 0.00 0
GVRP 0.00 0.00 0.00 0.00 0
ICMP 0.01 0.00 0.00 0.00 1
IP 0.00 0.00 0.00 0.00 0
OSPF 0.00 0.00 0.00 0.00 0
RIP 0.00 0.00 0.00 0.00 0
STP 0.00 0.00 0.00 0.00 0
VRRP 0.00 0.00 0.00 0.00 0
Brocade#show process cpu 2
Statistics for last 1 sec and 80 ms
Process Name Sec(%) Time(ms)
ARP 0.00 0
BGP 0.00 0
GVRP 0.00 0
ICMP 0.01 1
IP 0.00 0
OSPF 0.00 0
RIP 0.00 0
STP 0.01 0
VRRP 0.00 0