Displaying ospf interface information, Displaying ospf interface, Information – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual

Page 237

Advertising
background image

Brocade ICX 6650 Layer 3 Routing Configuration Guide

219

53-1002603-01

Displaying OSPF information

Displaying OSPF interface information

To display OSPF interface information, enter the show ip ospf interface command at any CLI level.

Syntax: show ip ospf interface [ip-addr]

The ip-addr parameter displays the OSPF interface information for the specified IP address.

The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.

Opt

The sum of the option bits in the Options field of the Hello packet. This information is used by
Brocade technical support. Refer to Section A.2 in RFC 2178 for information about the Options
field in Hello packets.

Cnt

The number of LSAs that were retransmitted.

Second-to-dead

The amount of time the Brocade device will wait for a HELLO message from each OSPF neighbor
before assuming the neighbor is dead.

TABLE 38

Output of the show ip ospf interface command

Field

Definition

IP Address

The IP address of the interface.

OSPF state

ptr2ptr (point to point)

Pri

The link ID as defined in the router-LSA. This value can be one of the
following:

1 = point-to-point link

3 = point-to-point link with an assigned subnet

Cost

The configured output cost for the interface.

Options

OSPF Options (Bit7 - Bit0):

unused:1

opaque:1

summary:1

dont_propagate:1

nssa:1

multicast:1

externals:1

tos:1

TABLE 37

CLI display of OSPF neighbor information (Continued)

Field

Description

Brocade#show ip ospf interface 192.168.1.1

Ethernet 1/2/1,OSPF enabled

IP Address 192.168.1.1, Area 0

OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1

Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40

DR: Router ID 0.0.0.0 Interface Address 0.0.0.0

BDR: Router ID 0.0.0.0 Interface Address 0.0.0.0

Neighbor Count = 0, Adjacent Neighbor Count= 1

Neighbor: 10.2.2.2

Authentication-Key:None

MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300

Advertising