Show commands for bgp null0 routing – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 346
328
Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
BGP null0 routing
Brocade(config-bgp-router)#neighbor <router4_int_ip address> remote-as 100
Brocade (config-bgp-router)#neighbor <router5_int_ip address> remote-as 100
Brocade(config-bgp-router)#neighbor <router6_int_ip address> remote-as 100
Brocade(config-bgp-router)#neighbor <router7_int_ip address> remote-as 100
Show commands for BGP null0 routing
After configuring the null0 application, you can display the output.
S6
The following is the show ip route static output for S6.
S1 and S2
The following is the show ip route static output for S1 and S2.
S6
The following is the show ip bgp route output for S6
Brocade#show ip route static
Type Codes - B:BGP D:Connected S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 10.0.0.40/29 DIRECT eth 1/1/2 1/1 S
2 10.0.0.192/27 DIRECT eth 1/1/2 1/1 S
3 10.0.14.0/23 DIRECT eth 1/1/2 1/1 S
Brocade#show ip route static
Type Codes - B:BGP D:Connected S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 199.199.1.1/32 DIRECT drop 1/1/1 S