Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 213)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 195
53-1002603-01
Configuring OSPF
NOTE
The ASBR must be running both RIP and OSPF protocols to support this activity.
To configure for redistribution, define the redistribution tables with deny and permit redistribution
filters. Use the deny redistribute and permit redistribute commands for OSPF at the OSPF router
level.
NOTE
Do not enable redistribution until you have configured the redistribution filters. If you enable
redistribution before you configure the redistribution filters, the filters will not take affect and all
routes will be distributed.
FIGURE 23 Redistributing OSPF and static routes to RIP routes
Example of redefining distribution filters
To configure theLayer 3 Switch acting as an ASBR in Figure 23 to redistribute OSPF, BGP4, and
static routes into RIP, enter the following commands.
BrocadeASBR(config)#router rip
BrocadeASBR(config-rip-router)#permit redistribute 1 all
BrocadeASBR(config-rip-router)#write memory
OSPF Domain
RIP Domain
Switch
Switch
ASBR (Autonomous
System Border
Router)