Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 277)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 259
53-1002603-01
Displaying OSPF V3 Information
The fields that display depend upon the LSA type as shown in the following table.
TABLE 45 OSPF V3 detailed database information fields
Field Description
Router LSA (Type 1) (Rtr) fields
Capability Bits A bit that indicates the capability of the Brocade device. The bit can be set to one of the
following:
•
B – The device is an area border router.
•
E – The device is an AS boundary router.
•
V – The device is a virtual link endpoint.
•
W – The device is a wildcard multicast receiver.
Options A 24-bit field that enables IPv6 OSPF routers to support the optional capabilities. When
set, the following bits indicate the following:
V6 – The device should be included in IPv6 routing calculations.
E – The device floods AS-external-LSAs as described in RFC 2740.
MC – The device forwards multicast packets as described in RFC 1586.
N – The device handles type 7 LSAs as described in RFC 1584.
R – The originator is an active router.
DC –The device handles demand circuits.
Type The type of interface. Possible types can be the following:
•
Point-to-point – A point-to-point connection to another router.
•
Transit – A connection to a transit network.
•
Virtual link – A connection to a virtual link.
Metric The cost of using this router interface for outbound traffic.
Interface ID The ID assigned to the router interface.
Neighbor Interface ID The interface ID that the neighboring router has been advertising in hello packets sent on
the attached link.
Neighbor Router ID The router ID (IPv4 address) of the neighboring router that advertised the route. (By
default, the Brocade router ID is the IPv4 address configured on the lowest numbered
loopback interface. If the Brocade device does not have a loopback interface, the default
router ID is the lowest numbered IPv4 address configured on the device.)