Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 283)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 265
53-1002603-01
Displaying OSPF V3 Information
This display shows the following information.
Displaying OSPF V3 neighbor information
You can display a summary of OSPF V3 neighbor information for the Brocade device or detailed
information about a specified neighbor.
To display a summary of OSPF V3 neighbor information for the device, enter the show ipv6 ospf
neighbor command at any CLI level.
Syntax: show ipv6 ospf neighbor [router-id ipv4-address]
The router-id ipv4-address parameter displays only the neighbor entries for the specified router.
This display shows the following information.
TABLE 48 OSPF V3 memory usage information
Field Description
Total Static Memory Allocated A summary of the amount of static memory allocated, in bytes, to OSPF V3.
Total Dynamic Memory Allocated A summary of the amount of dynamic memory allocated, in bytes, to OSPF V3.
Memory Type The type of memory used by OSPF V3. (This information is for use by Brocade
technical support in case of a problem.)
Size The size of a memory type.
Allocated The amount of memory currently allocated to a memory type.
Max-alloc The maximum amount of memory that was allocated to a memory type.
Alloc-Fails The number of times an attempt to allocate memory to a memory type failed.
TABLE 49 Summary of OSPF V3 neighbor information
Field Description
Router ID The IPv4 address of the neighbor. By default, the Brocade router ID is the IPv4 address configured
on the lowest numbered loopback interface. If the device does not have a loopback interface, the
default router ID is the lowest numbered IPv4 address configured on the device.
Pri The OSPF V3 priority of the neighbor. The priority is used during election of the DR and BDR.
State The state between the Brocade device and the neighbor. The state can be one of the following:
•
Down
•
Attempt
•
Init
•
2-Way
•
ExStart
•
Exchange
•
Loading
•
Full
DR The router ID (IPv4 address) of the DR.
Brocade#show ipv6 ospf neighbor
RouterID Pri State DR BDR Interface[State]
10.1.1.1 1 Full 192.168.223.223 10.1.1.1 ethe 1/1/3 [DR]