ACU-RITE MILLPWRG2 - Manual (Page 123)

ACU-RITE MILLPWR G2 105
6.2 F
o
lders
Other
Addresses
Description Comment
F † Set Feed Rate
The feed rate uses the current program units in effect (ipm or mmpm).
The setting applies to current and subsequent blocks. The default is
determined from MILLPWR
G2
's configuration setup.
I †
Arc center coordinate parallel
to X axis
These are the arc center coordinates for G2 and G3 arcs. They are
assumed to be programmed in incremental from the current tool
position.
J †
Arc center coordinate parallel
to Y axis
K †
Arc center coordinate parallel
to Z axis
N † Line Number
Line numbering is optional and for readability only. MILLPWR
G2
does
not make use of this information.
O † Program Number Used at the beginning of a program.
S † Spindle Speed
The spindle speed is set to the specified speed (rpm). If the spindle is
currently off (M5), it will not be turned on unless accompanied by a
spindle direction block (M3 or M4). The setting applies to current and
subsequent spindle direction blocks. The default is 0 rpm.
T † Tool Selection
This command is used to select the active tool. The tool is specified by
tool number or by its diameter. If the diameter is not specified, it is
retrieved from the tool table.
The program pauses at a tool command and prompts the user to
complete the tool change. Press GO to resume.
T(toolNumber) D(toolDiameter) L(toolLength)
X † X Axis Coordinate
The coordinates represent the destination for the G0, G1, G2, or G3
command currently in effect. They use the current units (G20/21 or G70/
71) and offset mode (G90 or G91).
Y † Y Axis Coordinate
Z † Z Axis Coordinate