ACU-RITE MILLPWRG2 - Manual (Page 50)

32 3 DRO Mode and Calculator
3.1 DR
O Manual D
a
ta Input
Status Bar Display
Status Bar
Display
Description
Program
State This field indicates the program state: Stop when
program is not running, Run when program is
running, or Pause when program is paused for
operator.
Feed This field indicates the current feedrate of the table
or quill.
Tool In DRO mode, this field indicates the current tool
selection. In PGM mode, this field indicates the
programmed tool for the highlighted step.
Datum This field indicates the active Datum number.
Scale This field indicates the active Scale factor.
Skew This field indicates the active Skew angle.
Units This field indicates the active display units. All
dimensions are displayed in these units (inch or
mm). The current feedrate is displayed in these
units (inch or mm per minute).
Estimated
Time This field indicates the estimated machining time for
the active program. This time assumes the program
runs at 100% of the programmed feeds. It does not
include the time necessary to perform manual
operations such as changing a tool.
Part Clock This field shows the cumulative running time of the
current program. The timer is reset when a program
is loaded.
Parts This field shows the number of times the current
program was run to create a part.
Job Clock This field shows the total elapsed time for the
current job. This timer is started and stopped by the
operator.
Time of
Day This field shows the current time.