ACU-RITE MILLPWRG2 - Manual (Page 135)

ACU-RITE MILLPWR G2 117
7.
1 Demonstr
ation Pr
ogr
am
Programming the upper angle Line
The upper line that angles away from the part will now be added.
 Press the LINE key.
With MILLPWR
G2
assuming that it is continuing from where it was left
off, all fields are filled in except for the TO: fields. Which is also where
the cursor is located in the first TO: field.
Using the numerical keypad, enter the following information:
 In the TO: X2 field enter -3.0, and ARROW Down.
 In the TO: Y2 field enter .838.
 Press the USE key.
Although changes are not lost if a power cycle occurs, you may wish
to save your program periodically while creating it, or you may want to
discard the most recent changes made since the last save.
 Press the Save / Discard soft key.
 Select Save from the popup menu to save the program, or select
discard to delete the most recent changes since the last save.
Next, a blend will be added to the two angled lines.