ACU-RITE MILLPWRG2 - Manual (Page 169)

ACU-RITE MILLPWR G2 151
8.1 Milling and Dr
illing
 ARROW DOWN or press the More soft key.
 The FINISH and FEED fields will assume the same as the previous
finish fields in the program if it exists. Otherwise this data must be
added if required, or leave it blank if not required.
 For DIRECTION, press either the CW soft key for a clockwise
cutting direction or the CCW soft key for a counter-clockwise cutting
direction.
 Press the USE key.
If the tool size and type listed in the TOOL field are incorrect, change
the tool settings before running your program.
Tool Path Description:
 Machining of the frame begins at the top of the circle.
 The tool plunges at the Z feed rate.
 The frame is milled in the directions programmed (CW or CCW)
 The Z step size is determined by the system and will not exceed the
specified distance or number of passes.
 The side finish allowance is optional and is only applicable to frames
with a tool offset. If specified, this amount is left on the side of the
frame to be removed on the finish pass.
 When finish feed is 0, the finish pass will be skipped.