ACU-RITE MILLPWRG2 - Manual (Page 51)

ACU-RITE MILLPWR G2 33
3.1 DR
O Manual D
a
ta Input
Move Table
The Move Table soft key when pressed will turn on the servo motors.
Pressing it again will turn the servo motors off.
The desired feed rate can be set, or it can be left at 100% for rapid
feed rate. See "Adjusting the Feedrate" on page 28.
To move the table in increments, first select the soft key increment
wanted (e.g. 0.001, or 0.01, or 0.1).
A 3 axes system allows the Z axis to be moved by selecting the soft
keys Move Z Up, or Move Z Down.
A 2 axes system requires the Z axis to be moved manually.
A 3 axes system allows the X, Y, (and Z) axis can be moved
simultaneously by pressing the desired direction ARROW hard keys at
the same time.
A 2 axes system allows the X, and Y axis to be moved simultaneously
by pressing the desired direction ARROW hard keys at the same time.
Milling Function
One Step Milling function may also be referred to as Single Cycle
milling functions. Most milling functions can be used as one time
machining operations as well as for programming. The BLEND key does
not support single operation. Each milling function will either open its
own dialogue or allow selection of choices from a soft key popup.
These milling function keys are described in more detail later in this
chapter.
Always fold in the table crank handles before moving the
table using the servos.
The axis move one increment per key press when using
step increment. The axis moves continuously until
released when using continuous jog.