ACU-RITE MILLPWRG2 - Manual (Page 143)

ACU-RITE MILLPWR G2 125
7.
1 Demonstr
ation Pr
ogr
am
 Press the Run Options soft key.
 Press the Graphics Only soft key to display the
machining steps. Displaying the graphics is not
required, but can be of assistance when executing
the dry run feature.
 Press the Dry Run soft key.
 Use the arrow up key to highlight step 001 of the
program.
 Press the Exit soft key.
 Press the GO soft key (the table will move).
Running the Program
 The first step in running a new program is to establish datum.
Remember to chose the center of the bolt circle as datum.
 Place the workpiece into a vise.
 Place the first tool of the program into the spindle.
 From the DRO screen, press the Move Table soft key. Using the
arrows, and soft keys, position the workpiece under the tool where
the center of the bolt circle’s datum is to be.
 After the table has been properly positioned, press the Exit soft key
to return to the DRO screen.
 Touch the tool to the top surface of your workpiece.
 Press the Datum soft key.
 Press the X = 0, Y = 0 and Z = 0 soft keys to establish the current
tool position as datum.
 Press the DOWN ARROW key.
 Set the Z retract position 1” above the workpiece.
 Press the USE key.