ACU-RITE MILLPWRG2 - Manual (Page 180)

162 8 Milling and Drilling
8.2 A
d
ditional Milling F
unctions
Change Steps
The Change Steps feature gives you the ability to change or edit the
depth, offset and feed rate of several steps simultaneously.
 You can use this feature from anywhere within your program and
does not require the specific step to be highlighted.
To Change Steps:
 From the PGM screen, press the Step Functions soft key.
 Press the Change Steps soft key.
 Enter the first and last step numbers that you would like to change
in the STEP RANGE field.
 Use the arrow keys to select each field that you want to change and
enter the new data.
 Press the USE key.
Highlight the changed steps in the program sequence, then press the
ENTER
key. Each step should include the new settings.
Shift Steps
The purpose of the Shift Steps feature is to transpose a range of
steps from one location to another on the actual work piece.
 This feature can be used from anywhere within the program, and
does not require the specific step(s) to be highlighted.
To Shift Steps:
 From the PGM screen press the Step Functions soft
key, then the Shift Steps soft key.
 Enter the first and last step numbers to be transposed.
 Enter in each axis field the distance to shift per axis. Leaving a field
empty will result in no shift per that axis.
 Press the USE key to apply the shift to the selected steps.
Highlight the changed steps in the program sequence, then press the
ENTER
key. Each step should show the new axis coordinates.