ACU-RITE MILLPWRG2 - Manual (Page 95)

ACU-RITE MILLPWR G2 77
6.1 Con
v
ersational Pr
ogr
a
mming
Program Errors
When an error is detected in a program, the step with the error is
highlighted in the program listing with a red "
x " symbol. Edit the
program step to correct the error.
Additional information about the error is added to the error log. See
"Error Log" on page 183.
Program Edited
 When a saved program is loaded, only the name and extention is
displayed.
 If the saved program is then edited, the program name will show an
asterisk at the end of the name.
 This tells the operator that the program has changed, but has not
been saved.
 Saving the program will remove the asterisk, or exit the program
without saving the changes.
 When a program that has been edited, but not saved, then it will
revert back to the last saved version when closed. The program will
not display an asterisk the next time it is loaded.
After correcting the errors, remember to delete them
from the error log. A quick method for deleting all errors
in the log is to press the “0” on the numeric keypad.
If there is more than one error in the program, only the
first step with an error will be highlighted. After correcting
the first error, the next error will be highlighted.