Rockwell Automation 20G PowerFlex 750-Series AC Drives - Manual (Page 307)

Rockwell Automation Publication 750-RM002B-EN-P - September 2013 307
Integrated Motion on the EtherNet/IP Network Applications for PowerFlex 755 AC Drives Chapter 6
When the axis configuration is set to Frequency Control, you can select one of
the following control methods that best suits the application:
• Basic Volts/Hertz
• Fan/Pump Volts/Hertz
• Sensorless Vector
• Induction FV
The selection options of the axis configuration within the Logix Designer
application Axis Properties, Frequency Control tab are shown here.
This table contains the possible axis configurations and corresponding control
modes of the PowerFlex 755 drive on the Integrated Motion on the EtherNet/IP
Network.
Axis Configuration P35 [Motor Ctrl Mode] P65 [VHz Curve]
Frequency Control:
Basic Volts/Hertz InductionVHz Custom V/Hz
Fan/Pump Volts/Hertz InductionVHz Fan/Pump
Sensorless Vector Induction SV Custom V/Hz
Sensorless Vector economy Induct Econ Custom V/Hz
Position Loop Induction FV Custom V/Hz
Velocity Loop Induction FV Custom V/Hz
Torque Loop Induction FV Custom V/Hz