Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 32)

Publication 1734-UM004F-EN-E - December 2012
22 Configure Your Module
Set the Thermocouple Input
Module Parameters Using
RSNetWorx After adding the module to the network, you must configure the modules for
use.
Configure the modules as shown in the figure.
You see a dialog with a series of tabs. Each tab provides options view or edit.
The tabs are shown in the following figure.
Refer to these dialogs for an explanation of features.
IMPORTANT
This chapter shows configuration in the online mode. Changes
set in this mode take effect when you download to the
individual module.
1. Right-click the module.
2. Click Properties to configure.
You can also left-click the module or name.
These are the tabs you click to
view the options.