Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 44)

Publication 1734-UM004F-EN-E - December 2012
34 Configure Your Module
Basic Setup
1. Select the type of RTD
you are using for
channel 0. Repeat for
channel 1.
2. Then select the scale
for channel 0. Repeat
for channel 1.
This is the error of Copper RTD (10
Ω
Cu427) in O hms. Enter value between
-250 and 250 in hundredths of Ohms
(such as 361 = 3.61
Ω
). If you are using a
copper RTD, this value is added to the
input reading before linearization.