Access calibration parameters in rsnetworx – Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual User Manual
Page 51
Advertising
Publication 1734-UM004F-EN-E - December 2012
Calibrate Your Module 41
Access Calibration Parameters in RSNetWorx
1. Double-click the icon of the module to be calibrated to bring up the
General Parameter dialog.
2. Click Device parameters.
The EDS editor may ask you if you want to upload the configuration
from the device.
3. If you do not see the EDS editor dialog, proceed with the next step;
otherwise, from the EDS editor dialog, click Upload.
ATTENTION
The dialog box layout varies depending on the version of
RSNetWorx software you are using.
Click Device Parameters to
view the parameters.
Advertising
This manual is related to the following products: