Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 39)

Publication 1734-UM004F-EN-E - December 2012
Configure Your Module 29
Set the RTD Input Module
Parameters Using
RSNetWorx After adding the module to the network, you must configure the modules for
use.
Configure the modules as shown.
You see a dialog with a series of tabs. Each tab provides options to view or
edit. Refer to the figure to see the tabs.
Refer to these dialogs for an explanation of features.
IMPORTANT
This chapter shows configuration in the online mode. Changes
set in this mode take effect when you download to the
individual module.
1. Right-click the module.
2. Click Properties to
configure.
You can also left click the module or name.
Click these tabs to view the
options.