Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 40)

Publication 1734-UM004F-EN-E - December 2012
30 Configure Your Module
Setting Parameters
The module name appears here.
Type a description here.
The module address appears
here. (This field is read-only.)
This dialog also shows the
module’s device identity.
These fields are read-only.
At any point, click here to finish changing
configuration parameters.
If configuration changes are made in offlin
mode, they do not take effect until the
system goes online.
Click the Device parameters tab to
get to the dialog for setting the
parameters.
This dialog appears after you click
the Device parameters tab. If you
want the existing parameters
uploaded from the module, select
Upload. The following dialog then
shows the existing parameters set
on the module.
Use this pull-down menu to edit or view the
parameters. Available choices are:
POINTBus
Status
Configuration