Rockwell Automation 1734-IT2I Thermocouple and RTD Input Module User Manual - Manual (Page 69)

Publication 1734-UM004F-EN-E - December 2012
Configure Modules in RSLogix 5000 Software 59
Alarm Configuration Dialog
This dialog does not appear for Listen-Only options. The dialog displays alarm
configuration parameters for each channel in individual rows on the grid. The
1734-IR2 module has two input channels. To complete entries on this dialog,
proceed as follows.
1. Click Alarm Configuration to display the dialog.
2. From the top of the dialog, at Channel click a push button to select a
channel, with the selected push button appearing pressed.
3. From the dialog, make entries, referring to the table that shows how to
complete entries for the channel you selected.
4. From the dialog, perform one of the following:
• Click a tab at the top of the dialog to continue making entries.
• Click OK to save changes and close the dialog.
• Click Cancel to return to default values.
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply
button when you make changes to any of the dialogs.