Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality User Manual
Page 24
22
Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
Chapter 2
PowerFlex HMI Interface Board
IP Setup with Forge Shell
1.
Press the ‘Maintenance’ button (
Figure 15 - Forge Shell
2.
Select IP Setup.
Figure 16 - IP Setup
3.
Select the MAC Address in the pulldown menu (
) that
corresponds to the MAC ID printed on the white label of the HMI
Interface Board (see
4.
Enter the IP Address, Sub Mask and Gateway address and click Apply.
This information must be obtained from your network administrator.
If the IP address is set to all zeroes, the module will be configured use a
Dynamic IP address assigned by a DHCP server, if one exists on the
network.
5.
After the HMI Interface Board module has reset in the Forge Shell
application, click Maintenance and Refresh.
The configured module now appears with its new IP address.